SCCH MKII / MKIII Rear Beam kit eliminates unwanted flex in the factory bushings for precise response of your VW Mk II/ Corrado g60-16v chassis. The Bearing inserts are precisely machined to be pressed into the rear beam of your car, And are easily serviceable when the bearing�s needs replacement.

This kit is designed to replace either the 1.760 diameter or 2.220 diameter beam bushing. Be sure to check which kit you need

The compliance in the factory bushings of your VW factory control arm offer ride quality by sacrificing compliance where you want it, and allowing where you don�t.

The VW MKII � MKIV Front spherical bushing kit allow your suspension to articulate freely without binding or springing and stops dynamic camber and toe changes due to the control arm moving under acceleration and braking while turning.

The bearing bodies are constructed from 6061 aluminum and anodized to prevent corrosion and the spacers and other hardware is either anodized aluminum or corrosion resistant stainless steel. The spherical bearings are easily serviceable by hand tools and can be done by the end user.

This kit pairs well with the SCCH Rear beam bearing kit, giving you the most compliant and bind free suspension which is necessary in a motorsports environment.

This kit does not fit R32 or 4wd TT cars.
This kit fits MkII � MkIV front control arms with the smaller 30mm front bushing which can also be found on:

• MkI 2wd Audi TT
• 2wd and 4Motion Beetle and Cabrio
• Corrado
• MkII � MkIV Golf (non-R32)
• MkII � MkIV Jetta
• B3 / B4 Passat

The compliance in the factory bushings of your VW factory control arm offer ride quality by sacrificing compliance where you want it, and allowing where you don�t.

  The VW MkIV R32 / 4Motion Front spherical bushing kit allow your suspension to articulate freely without binding or springing and stops dynamic camber and toe changes due to the control arm moving under acceleration and braking while turning.

  The bearing bodies are constructed from 6061 aluminum and anodized to prevent corrosion and the spacers and other hardware is either anodized aluminum or corrosion resistant stainless steel.  The spherical bearings are easily serviceable by hand tools and can be done by the end user.

  This kit pairs well with the SCCH Rear spherical bearing kit, giving you the most compliant and bind free suspension which is necessary in a motorsports environment.

This kit fits MkIV R32 front control arms with the larger 45mm front bushing which can also be found on:

• • MkI Audi A3 � 2wd and 4wd
  • MkI Audi S3 � 4wd
  • MkI Audi TT � 2wd and Quattro
  • MkIV Jetta � 4Motion